Absolute dating - Wikipedia
of archaeology. It can only define the antiquity in terms of older or younger than something absolute dating technique exhibit chronology in terms of years. Under relative dating there are different methods such as stratigraphy, typology. Relative dating includes methods that rely on the analysis of comparative data or the Absolute dating methods mainly include radiocarbon dating, Examples of such objects include very specific stone tools, different pottery. Before the advent of absolute dating methods, nearly all dating was relative. .. Scientific dating techniques have had a huge impact on archaeology. . as B.P., where B.P. stood for "before present" and "present" was defined as
Relative dating includes different techniques, but the most commonly used are soil stratigraphy analysis and typology. On the other hand, absolute dating includes all methods that provide figures about the real estimated age of archaeological objects or occupations. These methods usually analyze physicochemical transformation phenomena whose rate are known or can be estimated relatively well. This is the only type of techniques that can help clarifying the actual age of an object.
Absolute dating methods mainly include radiocarbon dating, dendrochronology and thermoluminescence. Relative Dating Stratigraphy Inspired by geologystratigraphy uses the principle of the superposition of strata which suggests that, in a succession of undisturbed SOILSthe upper horizons are newer than the lower ones.
Generally, each stratum is isolated in a separate chronological unit that incorporates artifacts. However, this method is sometimes limited because the reoccupation of an area may require excavation to establish the foundation of a building, for instance, that goes through older layers. In this case, even if the foundation of the building is found in the same stratigraphic level as the previous occupation, the two events are not contemporary.
- Principles of Prehistoric Archaeology. Chronology: Relative and Absolute Dating methods
- Dating methods
- Dating in Archaeology
Stratigraphic dating remains very reliable when it comes to dating objects or events in undisturbed stratigraphic levels. For example, the oldest human remains known to date in Canada, found at Gore Creekhave been dated using soil stratification.
The bones were buried under and are therefore older a layer of ash that resulted from a volcanic eruption dating back to years BP Before Present; "present" indicates c. Subsequently, radiocarbon dating, an absolute dating technique, was used to date the bones directly and provided a date of BP, showing how useful the combined used of relative and absolute dating can be.
Moreover, stratigraphic dating is sometimes based on the objects that are found within the soil strata. Indeed, some items whose exact or approximate age is known are called "diagnostic artifacts.
Their presence on archaeological sites is used to date the soil layers and the objects and events they are associated with and thus contributes to refine the chronology of sites. Typology Typology is a method that compares reference objects in order to classify them according to their similarity or dissimilarity and link them to a specific context or period.
This technique is frequently used when it is impossible to make use of absolute dating methods; it generally allows archaeologists to identify the period to which a cultural site or object belongs, without specifying the date of occupation. This method is primarily applied to projectile points and ceramic vessels. These present many characteristics that are used for comparing them, such as morphology and raw materials in the case of stone tools, and decorative techniques and motifs in the case of ceramics.
Absolute Dating Radiocarbon Dating Radiocarbon dating is the most widely used dating technique in archaeology. It relies on a natural phenomenon that is the foundation of life on earth. Indeed, carbon 14 14C is formed from the reaction caused by cosmic rays that convert nitrogen into carbon 14 and then carbon dioxide by combining with carbon 12 12C and carbon 13 13Cwhich are stable carbon isotopes.
Following the death of an organism, any exchange ceases and the carbon 14, which is radioactive and therefore unstable, slowly begins to disintegrate at a known rate half-life of years, ie, after this period only half of the total carbon 14 present at the time of death remains.
A sample requires 10 to 20 grams of matter and usually consists of charred organic material, mainly charcoal, but bones see zooarchaeology and shells can also be dated using this technique. An initial reading dates the specimen which is then calibrated by considering this date and its correspondence with the measurable level of carbon 14 stored over time in the growth rings of certain tree species, including redwood and pine bristol.
Subsequently, the calibration of that date provides a time interval where the event or object being dated can be situated eg, AD. Radiocarbon dating, however, can only be used for dating objects that are less than 50 years.
Dendrochronology Dendrochronology is a method that studies the rings of tree trunks to define characteristic sequences by analyzing the morphology of growth rings for a given species.
How to collect samples: While collecting samples for radio carbon dating we should take utmost care, and should observe the following principles and methods. Sample should be collected from and undisturbed layer.
Deposits bearing, pit activities and overlap of layers are not good for sampling. The excavator himself should collect the sample from an undisturbed area of the site which has a fair soil cover and is free of lay water associated structures like ring wells and soakage pits. Samples which are in contact or near the roots of any plants or trees should not be collected because these roots may implant fresh carbon into the specimens.
Handling with bare hands may add oil, grease, etc to the sample. Therefore, it is better to collect samples with clean and dry stainless steel sclapels or squeezers. It may also be collected with the help of glass. Stainless steel, glass, polythene and aluminium are free from carbonatious organic material.
Dating in Archaeology | The Canadian Encyclopedia
Therefore sampling should be done with such material only. Samples should be sundried before pacing in aluminium thin foils and placed in a glass jar or secured safely in thick polythene covers. Before pacing the soil should be removed while it is wet at the site. Method of Sample Recording: Before removing the sample from the site we should note down the data or the environment of the sample.
We have to fill the data sheets, which should be done at the time of sampling and should be submitted along with the sample to the dating laboratory. These sheets require data on environment and stratigraphy of the sample, and archaeological estimates of its dating.
This data help in obtaining and objective interpretation of dates. Limitation and Errors of C Dating: There are a number of technical difficulties inherent in this method of dating. The first difficulty is that the quantity required for a single determination is comparatively large.
It will be difficult to obtain sufficient quantities of samples, especially in the case of valuable museum specimens.
Absolute and relative dating methods in prehistory
The second difficulty is that the radio active decay does not take place at a uniform rate but is a random process, and is therefore, governed by the laws of statistical probability. Another difficulty that has to be taken into serious consideration is the possibility of uneven distribution of radio carbon in organic matter.
If the specimen is analyzed after having been exposed to contamination by carbon compounds of an age younger than its own, radio carbon age is liable to be reduced.
The best results can be obtained from specimens, which were preserved under very dry conditions, or even enclosed in rock tombs of the like.
Very dangerous contamination is done, very often, by the growth of fungus and bacteria on the surface of the specimen which even when removed from the specimen may falsify its actual age. Though there are some drawbacks and technical difficulties, the radiocarbon method is a reliable, efficient and most useful method of dating the archaeological specimens.
We are helpless in the case of contamination done by the natural agencies in the past, but we can overcome most of the difficulties by paying sufficient care and attention while collecting the samples. It is the duty of an archaeologist to study with care the condition of preservation of specimens submitted for analysis and, in fact, to submit only specimens that can be regarded as fool-proof as is possible in the circumstances.
A major application of dendrochronology in archaeology, as a tool for establishing dates from the samples of wood and articles made out of wood is not only in working out primary chronologies but also in cross checking the already known dates by other methods.
Often, the tree-ring analysis from a site can give strong clues about the length of occupation, certain periods of building or repair activities at the site. Another application of tree-ring analysis is the inference of past environmental conditions, which is extremely useful to the archaeologists. The modern science of dendrochronology was pioneered by A.
Tree ring analysis is based on the phenomenon of formation of annual growth rings in many trees, such as conifers. These rings are shown by the trees growing in regions with regular seasonal changes of climate. As a rule trees produce one ring every year.
When growing season rainy season begins, sets of large, thinly-walled cells are added to the wood. This process repeats in the following years also. The formation of rings is affected by drought and prosperous seasons. In the years with unfavourable weather the growth rings will be unusually narrow. On the other hand, during years with exceptionally large amounts of rain the tree will form much wider growth rings. Most of the trees in a give area show the same variability in the width of the growth rings because of the conditions they all endured.
Thus there is co-relation between the rings of one tree to that of another. Further, one can correlate with one another growth rings of different trees of same region, and by counting backwards co-relating the inner rings of younger trees with the outer rings of older trees we can reconstruct a sequence of dates.
By comparing a sample with these calendars or charts we can estimate the age of that sample. Thus it is possible to know the age of the wood used for making furniture or in the construction work. The main disadvantage with the system is that, we require a sample showing at least 20 growth rings to make an objective estimation of its age. Hence smaller samples cannot be dated.